Welcome to the Ultimate Crew !!!

 

Please read everything carefully.

• If you already have the light-up pony, you’ll need to switch to the new connector to use the ULTIMATE, or the LEDs could be damaged within an hour.

• Not installing the ULTIMATE with its connector will void the warranty.

• Use the right side, the passenger side headlights.

• If you don’t want to drill the hole bigger (3/8") to route the connector attached to the front Pony, you can easily depin it. Just push a flathead lightly on the metal on the red and black side and they will pull out easily. Just remember black goes on left and red goes on right (if looking at metal side). This will make for MUCH easier routing through the hole.

• Take a picture before removing the plug to avoid connecting the wrong wires.

 

Front Light-up Pony video installation:

Dual Connector Instructions:

 

Connect the black wire, and only connect either the yellow or the red wire—never both. See pictures for reference.

 

1. Yellow with yellow to headlights. DO NOT CONNECT THE RED WIRE.

 

2. Connect the red wire to the red wire for the welcome lights or DRLs. Do not connect the yellow wire. This method works across Europe, the United Kingdom, Canada, New Zealand, and Australia. In the USA, it works with some models but not with others.

 

3. If connecting the red wire to the red wire doesn’t work, certain models might need to be connected to the ACC connection (wire/posi tap included) to work with the DRLs. While it’s possible to connect to the DRLs this way, we take no responsibility for this installation method; however, it is still covered under the warranty.

 

Passenger-side footwell 

Connect long red wire with the Orange/Green wire

 

Step 1

Step 2

Step 3

Front Pony video installation:

LIGHT-UP PONY TUTORIAL by BSKT Design, for the Mustang Mach-E.

Rear Pony video installation:

https://www.youtube.com/watch?v=yGzXAGtcj0k&t=980s

 

Tip: How to stick the pony properly?  

Thoroughly clean the surface where the pony will be attached. Tape around the original pony as a guide, clean the spot well, and let it dry. Heat both the 3M tape and the spot on the car, then use the tape as a guideline to position the pony. Press firmly for one minute, remove the guide tape, and clean the area again. Tape over the pony to keep pressure on it overnight, and avoid washing your car for a few days.

To remove the pony, heat it well, cut the tape with a fishing line, and locate the two clips. Don’t force it—cut as much as you can and use a plastic trim tool for assistance. Tape around the pony to protect it, as some damage may occur.

Spread the word,

We’d really appreciate your help—just leave a review on the product page. It’s quick, simple, and makes a big difference.

REVIEW   Ultimate Pony – 2026 Light-Up Pony Mustang Mach-E Upgrade – Bskt Design , go all way down to the bottom of the page and "write review" (green)

Let’s share ULTIMATE with the world.

It’s the coolest, most beautiful logo on the streets ever!

 

Our products are exclusive from ©BSKTdesign2026 🐎